Preventing Major Automobile Air Conditioner Failure
By Tom Massey, Owner, Auto Air & More and T & A Service and Supply

Since the air conditioner is probably the second most expensive part of the automobile, next to the engine, you should know what causes air conditioners to fail.

The most common cause of failure is contamination of the system and leaks. All air conditioners have an accumulator or receiver-dryer that holds a chemical desiccant that absorbs moisture. Air and moisture goes to the hoses, especially nylon hoses, and enters the system even though there is pressure in the system. Filter-dryers are designed to hold enough desiccant to absorb the moisture that will enter a system in one to three years time. Of course in the real world, variations in climate and conditions may cause them to become saturated in a few months or as long as a few years. However, if the system is opened for any reason, leaks or accidents, it may be saturated in minutes. The important thing is at some point the dryer becomes saturated and will no longer absorb the moisture. At this time, the desiccant will start to come apart and powder. Also, the moisture will react with refrigerant (Dichlorodifluoromethane) to form Hydrochloric and Hydrofluoric Acids. These acids eat away at the metal and aluminum and also react with the oil and hoses in the system. As bits of material start to flake off they collect at the accumulator, dryer, expansion valve, orifice tube, and compressor, as well as the bottom of the condenser. This can slow or block the flow of oil back to the compressor and cause compressor failure.

A typical air conditioner only has seven to thirteen ounces of oil in the system. This oil mixes with and depends on the flow of refrigerant to circulate to the system. When a leak occurs, oil is lost along with the refrigerant. Oil traces usually can be seen at the point of leakage. Too little oil in the system will surely result in compressor failure. Too much oil in the system will cause loss of cooling and could result in broken valves in the compressor.

When your system becomes low on refrigerant it is IMPERATIVE that the location of the leakage be determined and repaired. Since the oil is distributed to every part of the system, many times the only way to know just how much oil is left in the system after a major leak has occurred is to flush the system completely, taking all of the oil out so the proper amount of oil can be added back to the system. Converting a system to new alternative environmentally safe refrigerants also requires removal of old oil.

Certainly, if a compressor fails, the system must be flushed to remove the contaminated oil and metal particles before a new compressor is installed. No one would ever allow a new engine to be replaced in their car without installing a new oil filter and oil. Still for some reason people often purchase and install a new A/C compressor without flushing the system or replacing the filter-dryer or accumulator. When this happens a repeat failure usually will occur or the acids will build up and destroy the system.

To get the maximum performance and service out of your air conditioner, follow these basic rules:

  1. If the system fails to cool, turn it off and have it checked. Don't continue to run a system that is not working right. You may cause additional damage to it.
  2. Make sure you have good air flow through the condenser and radiator. Make sure the electric cooling fan runs when the air conditioner is on. This is very important to keep pressures down. No air flow for as little as 30 seconds can cause pressures to be as much as 200 pounds too high.
  3. Air conditioners on today's cars run in the winter as well as the summer to dehumidify the air. If your A/C quits in the fall don't leave it open to the air and moisture all winter. Have it serviced right away. Have the system checked at least twice a year to make sure you don't have leaks allowing the oil to be lost from the system.
  4. Most importantly, if you are involved in an accident or have to service the system, make sure the filter-dryer accumulator is replaced to stop acids from forming in the system.
  5. Don't chance air conditioner service to just anyone who owns a set of gauges. Make sure your service people fully understand proper A/C service procedures.

We are equipped to fully service or install a complete air conditioner system as well as convert your present system to alternative refrigerant using EPA approved equipment. We can make up or repair most A/C hoses. Often it is more economical to use new or rebuilt parts versus used parts. Stop by T & A Service & Supply or Auto Air and More for an inspection of your A/C system. We feel it is important for our customers to understand that cars have changed, federal regulations have changed and service procedures must also change to meet the demands of today's vehicles. We are committed to the betterment of the service industry and support the code of ethics of the MACS (Mobil Air Conditioning Society) and the IMACA (International Mobile Air Conditioning Association).

- Back to Top -

T&A Service & Supply
(Parts & Service)
Sioux Falls, SD

3412 South Minnesota Avenue Sioux Falls, SD 57104
Toll Free: (800) 658-3423
Voice: (605) 339-9717
Fax: (605) 339-0884
info@tandaservice.com

Auto Air & More
( Parts & Service)
Las Vegas, NV

4295 W. Tropicana Ave. Las Vegas, NV 89103
Toll Free: (888) 658-3423
Voice: (702) 362-2722
Fax: (702) 362-9694
info@autoairandmore.com

Send mail to webmaster.ta@tandaservice.com with questions or comments about this Web site.